1. Anti -slide board manufacturers talk about the manufacturing method of non -slip plate

Thick straight -line non -slip plates usually need to be treated strongly. The water content of low -density sheets with a thickness of 3 mm should be controlled at 20%to 30%, and it can generally be compressed with a drum device. During the processing process, the single board can be compressed to half of the original thickness by passing the pressure roller through the pressure roller under the processing liquid. When it leaves the press roller, it tends to restore its original thickness, and then it will absorb the solution.

For the treatment of non -slip plate with a thickness of more than 16 mm, the treatment tank is mainly used for pressure impregnation. The standard treatment method is to put the non -slip plate in a slot equipped with 30%~ 35%resin solution. After soaring on both sides, put it on the top of the veneer. Then use the roller to send the bracket with a single board to the processing tank. Depending on the penetration, the pressure of 0.15 ~ 1.5 mPa is applied. The insulation time is 1 minute to 6 hours, and the non -slip plate with a thickness of 16 mm is treated at a pressure of 0.2 ~ 0.3 mPa for 5 minutes. 30%. It needs to be treated under the pressure of 0.53MPa for 2 to 6 hours

The processed non -sliding plate should be stacked and covered densely, stored for 1 to 2 days, so that the resin is distributed evenly through the diffusion, and then dry. The drying speed should not be too fast to prevent too much resin to the surface. The reasonable process is 60 degrees dry 8 hours or 72 degrees dry 3 hours. In order to ensure the aggregation of the resin, the dry and humidity of the room should be increased to 95 drying for a thousand days, or the anti -skateboard dryer heated to 150 drying for 1.5 hours to prevent the anti -skateboard from being compressed in the heat compressor in the subsequent layer pressure.

2. What is the non -sliding board process of non -sliding board manufacturers?

Some non -slip plate manufacturers recommend that you wipe the tables regularly with soap and water. Although natural soaps with mild nature, such as soap (made of animal fats and alkali) and Murphy oil soap (made of vegetable oil and alkali), do not damage the surface of the coating, but excessive contact with water will cause damage to damage will cause damage to damage will cause damage to damage. Essence

If the surface treatment of the anti -skateboard has cracks, the water will penetrate below, causing the coating and wood to produce folds and separation. For example, the surface treatment of the coating degradation or wear, and excessive contact with the water can also cause the surface to depression. Therefore, only the anti -skateboard is soap and water to prevent the coating from degrading. How to prevent degradation caused by light, oxidation, and physical injury? In fact, most of you can do are passive, and active maintenance measures have little effect. Passive protection of the surface of the furniture to treat coating is to maintain continuous coverage and stay away from destructive factor.

In order to protect the anti -skateboard, the non -slip plate manufacturer recommends putting it in a place where the sun can be directly shot, using curtains and shading cloths, and a tablecloth on the desktop. In order to slow down the oxidation process, non -slip plate manufacturers recommend not to put the non -slip plate in the attic or other relatively hot places. High temperature will accelerate oxidation. In order to reduce physical damage as much as possible, non -slip plate manufacturers recommend using insulation pads, coasters, dining cushions and tablecloths, but plastic cloth cannot be covered with non -slip plates because plastic is easy to deal with surface treatment.